1, machine tools should be connected by professional electrical wiring, should ensure that the electrical parts dry.
2: power supply: if the power failure caused the machine to stop, should immediately turn off the main power supply, and check the mold
Is it damaged and should be replaced if it is broken?.
3, before production, must check all parts of the abnormal, no mechanical hazards, start the oil pump, check
Check all parts of the circuit is unobstructed, such as all normal, appropriate air transfer to the rear can be born
Production.
Start the machine must pay attention to the smooth flow of oil.
Heading machine should be paid attention to:
(1) check whether the bolts and nuts of each part are loose.
(2) inject the lubricating oil as specified.
(3) rotate the flywheel about two times manually or instantaneously to see if it is turning smoothly.
Attention should be paid to the use of thread rolling machine:
1. before driving, you should carefully check whether the parts are normal, two, whether the balance of rubbing silk plate, after rubbing normal, can be produced.
2. all the protective devices on the machine shall be in good condition and shall not be disassembled at will.
3.. Do not touch the moving parts and the rubbing plate in the running. No adjustment while driving.
4., before you stop rubbing the wire, you should stop the blank supply, to be two, there is no blank when you rub the silk plate, you can cut off the power supply.
5., such as temporary power outages and other failures, and when the thread between the folder has a blank, should be ruled out by law, not forced to drive.